Profile & specs
Board & Batten at a glance
- Coverage
- 16″ per panel
- Profile
- Raised batten
- Batten spacing
- 16″ on center
- Fastening
- Screw-down siding
- Gauge
- 24 ga, 26 ga or 29 ga
- Use
- Walls only
- Lengths
- Cut to your order
Wide flat faces and raised battens create a crisp vertical pattern. This profile is designed for siding, not roofing.
A whole exterior or an accent
- Barndominiums and shouses
- Modern farmhouse homes
- Gable accents above other siding
- Garages designed to match the house
Start with straight walls
- Flat, straight framing or sheathing helps the vertical lines look their best.
- Plan corners, windows and doors before ordering so the trim works with the panel layout.
- Choose matching trim for a subtle finish, or contrast the trim and lower wall section.
On-site roll forming
Made to length, right at your job
Our portable roll former can run Board & Batten panels at your job site. Tell us where you’re building and the panel lengths you need, and we’ll talk through the setup and schedule.
Colors & trim
The details finish the look
Consider the siding, roof and trim together. A light wall with dark trim outlines the building; matching wall and trim colors lets the vertical pattern stand out.
At corners and edges
- Outside and inside corners
- Base trim along the bottom
- Gable trim at the roofline
Around openings and accents
- J-channel for panel ends
- Door and window head trim
- Wainscot trim where wall finishes meet
We recommend ordering the trim with your siding so the shop can coordinate the finish and pieces.

The vertical lines up close
The raised battens break up the wide walls. Dark trim finishes the corners and the edges around windows and porch roofs.
Helpful answers
Board & Batten FAQs
How does metal board-and-batten siding compare with wood?
Metal Board & Batten gives you broad flat faces and raised vertical battens without wood rot or the need to stain wood. Painted metal still needs care, and its finish and warranty depend on the product you choose. This profile is designed for walls, not roofs.
Can you form these panels at my job site?
Yes. Our portable roll former can produce Board & Batten panels at your job site. Tell us the location and the lengths you need, and we will talk through access, setup and scheduling.
What trim will I need around windows, doors and corners?
Most jobs use inside and outside corners, J-channel at panel ends, and head trim above doors and windows. Base, gable and wainscot trim finish other edges and transitions. Bring a sketch or photos of your walls so we can help list the pieces.
Plan the rest of your project

